You can set a new WiFi name or you can set the name of the primary WiFi. Wireless Network Name SSID – Set the name for the new extended WiFi. On the bottom of the page, there is a section – Virtual interfaces. Wireless network name(SSID) field – in there, enter the WiFi of your primary router, the WiFi you use and which we need to extend. Anyways, set those parameters to match your primary router. Your router can have the same setup or it can have – a mixed Wireless network mode(B+G+N) or just two Network modes. Example – my primary router works only in N mode and has channel width of 20 Mhz. Wireless network mode and chanel width needs to be exact as on the primary router. For gateway field enter the primary address of your primary router of which we need to extend the WiFi. For – Default GW mode, check the option – Manual. First option – Wireless mode, change it to – Client bridge(Routed). Open the Wireless tab and under that, navigate to the basic settings. Make sure to write it down so you can access it later and to avoid reseting it to factory defaults. Router will prompt you to change the admin user name and password. It’s default IP address to access is – 192.168.1.1. Once you gather all that info and you installed DD-WRT on your router, login to the DD-WRT router. Encryption type of the password for the WiFi,Īll these information can be acquired once you login in your router and check for LAN or DHCP section and WLAN or Wireless section.From your primary router, you need to know the starting IP address from it’s DHCP server – some routers start their IP pool from 192.168.1.100 or something like that,.Primary IP address of your current router which provides WiFi,.There are couple of parameters that are necessary to acquire in order for this to work: Necessary information to acquire before configuration
And on this post we are going to cover the process how to setup a DD-WRT wifi repeater bridge. We already covered the installation process of DD-WRT on TP-Link routers, which you can check out here.
It supports many commercial grade routers(ASUS, Tp-Link, D-Link, Linksys etc…).īasically what it does – once you install it on your router, your router is then equipped with many tools that can often be found on enterprise grade routers. It’s packed with many features and various tools which can be quite useful. DD-WRT is an open source universal router firmware. Why do that? To effortlessly extend your WiFi’s signal range. This article is intended to be a guide for the steps on how to setup a DD-WRT WifI repeater bridge.ĭD-WRT is really a powerful router firmware and one of many cool things you can do with it is – to setup a WiFi repeater bridge. How to setup a DD-WRT WiFi repeater bridge Overview